The Build
Every Session x Teak piece starts as a design our own crew rides before it goes into production. We laser cut the parts from high grade Baltic birch plywood, glue and assemble them by hand, then hand sand every edge until the lips and landings feel finished. Every obstacle is handcrafted start to finish in our Rochester, NY shop. Session Fingerboards is part of the Teak Tuning family, and the Session x Teak collaboration line is where our fingerboarding obstacles come from.
Materials and Wear
Birch structure with acrylic across every surface you'd actually ride. The acrylic scuffs as you use it, which is wear, not damage. Store it flat so the benches stay square to the table.
Care
Keep it dry and indoors. Plywood swells if it sits in moisture, so keep it off damp surfaces and wipe it with a dry cloth. Use a dry cloth on the acrylic and skip solvents and polish, they haze the finish.
A Baltic birch fingerboard picnic table, 25cms long, with dual teal acrylic coping down the tabletop and both benches fully acrylic topped.
Most obstacles give you one edge. This gives you five. Coping runs the full length of both tabletop edges, and each bench is covered end to end, so you can grind the table, drop to a bench, and carry out the far side without ever leaving acrylic. It's long enough to build a line on rather than a single trick, and it looks just as good parked on a desk between sessions.
- Size: 25cms x 15cms x 7cms
- Coping: dual teal acrylic, full length of both tabletop edges
- Benches: both fully acrylic topped, grindable end to end
- Grind edges: five across one obstacle
- Build: laser cut, glued, and hand sanded in Rochester, NY
Includes: 1 Picnic Table, fully assembled. Fingerboard not included.